@harmonyards posted:How’d you do it??.....please share!..
Pat
Ok, let’s see if I can put it into words... motor removal requires removing the boiler shell from the chassis, then removing the lower cover from the frame followed by removing the drivers. The motor bracket is then unscrewed from the frame (the screws are behind the rear drivers). The motor then unscrews from the bracket, and the hole is big enough that the worm gear fits thru...
The worm gear is very securely pressed on to the motor shaft. There’s probably an appropriate puller, but I don’t have one... I used some pliers, a hammer, and a tiny screwdriver to drive the shaft out of the gear. Not pretty, but it worked... I used a c-clamp to press the gear onto the new motor. I made extra sure the other end of the c-clamp was only touching the other end of the motor shaft to avoid damage, and I carefully pressed the gear on a tiny bit at a time...
Reassembly is basically the reverse of disassembly. I found it easier to remove the side rods before reinstalling the drivers because it’s a bit fiddly to get the drivers in sync with each other due to the idler gear between the drivers...
Hope that helps!
