@Engineer-Joe posted:I'll go look again!
I’ll reply to this one so I’m not dragging pictures all up and down the thread,....that’s got a bottom plate, that just made the job a whole lot easier,.....those geared axle sets will come out the bottom, and can be serviced on the bench,.....all we need now is a couple gear boxes in a much more reasonable ratio,.....even if they’re singles, no worries, ....to be sure I can figure out how to machine a stub shaft out the end of one of them, then we’ll borrow parts from the RC guys, they have 4mm telescoping universal joint drive shafts in a dizzying array of lengths, ......this is a doable project, ....just got to find gear boxes,......compounds would be best, so you don’t see the drive shaft sitting just above chassis height....
I thought after the motor tobago you’d parked that thing, .....I’m glad you’ve revived it,....I don’t like quitting,....😉
Pat
