@RSJB18 posted:Nice job Darrell. The DCC board is much smaller without the need for power conversion. Sounds good too.
Bob
Thanks, actually easier than doing ERR since sound and control is on one board. There was enough room left I kept the smoke unit in place, if I want to use the proto couplers I have to make and install a small board to operate them. The same circuit can be used to turn on the smoke also so it is on the list of things to do. I was able to get a Digitrax 8 amp starter set for under $400 and wired it thru a DPDT switch to the layout so I can go back to DCS/TMCC when needed. The Digitrax throttle is wireless and has 2 speed knobs, makes is really easy to run 2 trains at once and can address over 9000 locomotives! The command station only runs 100 loco's and throttles, although they do have one that runs 400 loco's and throttles. My collection is nowhere near that big so it should cover all my needs in the future.
