The problem is definitely too much play in the rear axle. I have pulled the whole rear axle assembly and replaced with a good axle(no wheels or gear attached) and the play is very significant(most of the play is up and down). You a can see just by looking there is too much wear in the chassis. So my quandary is how do I repair it? I know with this kind of problem on some diesel chassis you can re-drill and re-sleeve the chassis, but I can find no such references to this type remedy for steamers. Has anyone repaired this type chassis problem on an AF Steam Engine. Yes it was properly quartered there was no binding or locking between the drive wheels, connecting rods etc. I have replaced the AF motor with a "can" motor and electronic E unit. I will also check and replace the other wheels and axles as necessary
My sincere apology for posting without being more clear what the exact issue is and I certainly appreciate all the quick responses to my post. I again appreciate any help, comments, suggestions, links whatever. I hate to have to discard the whole chassis and try and find a replacement without the same issue(s)..
Sgaugian - I agree there is nothing more beautiful then all the wheels rods and pistons working in unison, Unless the wheels are wobbling.... :-) I believe I corresponded with you earlier on another 'Channel'... Appreciated your comments there too.
Laurin
