Clem,
how is an app refresh done ?
As follows:
- Launch the app.
- Tap "Run My Trains" to get to the Engine Control Screen.
- Turn on power for all engines that you want to be active.
- Wait a full 3 minutes for WIU LEDs to stabilize. That means on steady, not blinking, although the WPS LED may flicker occasionally.
- Tap the Refresh button. It's the circular arrow at the top-left corner of the Engine Control Screen.
- Tap the Engine Roster button. It's the "V" at the top-right of the screen.
- The Engine Roster will appear.
- Select an engine by tapping on it.
- Tap the up-arrow at the top-right of the screen.
- Run the engine.
And then clone my remotes from I phone ?
Sorry, you cannot.
The process only works from remote to app, and app to app. Not from app to remote.
Now, buy the book.
This and a whole lot more about DCS WiFi is all in “The DCS WiFi Companion 1st Edition!" This book is available as an eBook at MTH's web store! |