@harmonyards posted:1. Mark, the eccentrics are held in place by solder only. The eccentric has a square hole, and the end of the crank pin is squared for alignment. If you should decide to disassemble, keep the clock positions noted for reassembly.
2. I believe Iām the one that got that E6 tender from you for a project I had built ā¦ā¦I put it to good use,ā¦.š
1. Thanks for the info; I see a very similar discussion taking place in the 2 rail group... regarding the same engine.
2. Yes, it was you; glad you had a use for it! š
Mark in Oregon