Skip to main content

Reply to "Williams Zinc Pest a real pest"

@Strummer posted:

As it is, I've JB'ed the heck out of it; will see how long it takes to fall apart again...

Mark in Oregon

An update of sorts...

I basically encased the entire part in the JB Weld; since it's not readily seen, it wasn't necessary for it to look "neat". I just had to make sure it would still be able to be "seated" properly.  It'll be a week tomorrow and so far it's holding.

This is a good looking (and with the new #555 motor) running engine, so I'm keeping my fingers crossed. 🙂

Mark in Oregon

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×