Skip to main content

Reply to "Wiring an Atlas 6924 N-D Board w/ #57 Switch Control"

Mike/Steve, thanks for the quick replies.

 

FUSE:  .....Fuse is installed in the track power circuit that feeds the small dead rail sections center of switch through the board......If I'm not using power routing where would fuse go?  Seems like between KW Power Feed and board J1 SW PWR IN.  Correct?

 

TERMINAL BLOCKS:  Per Stewart's post he is using Terminal Blocks.  Don't see them on your board Mike....although they may be above the picture wiring.  If Terminal Blocks are used like Stewart's can I feed, ie., multiple 6924's into the same Terminal Blocks to cut down on space/adding more blocks?  Basically ie., sending, ie., 4 set's of wires from 4 separate 6924's to respective Terminal Block poles, etc.

 

Mark

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×