Skip to main content

Reply to "Wiring Atlas O signals"

It very well could be a bad board as I stated above.  It does happen.  Put a piece of tape on the boards that don't work.  Check the picture of my under-table installation.  Make sure your signal cable is going into the correct plug socket (middle of the board).  See the picture of several of my boards at the interlock.

Look at the four boards on the right side of photo.  The board at the very top does not have a signal plugged into it yet.

There are also three photos of the Target Signal for the Bridge traffic.  More were added later for the opposite direction.

Sincerely, John Rowlen

DSCN0926

 

Attachments

Images (4)
  • DSCN0926
  • DSCN0922
  • DSCN0923
  • DSCN0924

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×