Not sure how far you want to go. You can easily extend the insulated section on either (or both) side(s) of the gate. If you take a standard 10" section and turn it over you will see silver colored strips connecting the two outside rails. Use a small screwdriver to lift the tabs and remove those pieces and press the tabs back down. Insert this 10" section next to the gate section and then one of the 5" insulated sections. Since the outside rails are no longer connected you have extended the trigger for the gates by 10". This can be done to any piece of FasTrack and will work as long as you have an insulated section at each end. Alternatively, in addition to removing the connectors from the bottom, you can remove the rail connector from one side at the end of the track or cut through the rail and on side and make your own insulated track. It's a good idea to mark any altered track section so you can recognize it later on.
|
|
