ADCX Rob posted:Follow the brown wire down from the reverse unit... it should be connected to a yellow wire and a blue wire on the terminal block. If it is, disconnect two blue wires from the terminal block and connect them to each other(or, disconnect two yellow wires and connect them to each other if that's easier).
That's it!
Thanks Rob. So the "Terminal Block" would be the square piece just left of center, in the photo ? The two Blue wires OR the two Yellow wires that are heading down into the terminal block are the ones you are talking about, correct ? Either set, the blue or the yellow can be cut and spliced ?
This picture may be a bit clearer. I didn't remove what I think is the E-Unit, which is toward the right.