Skip to main content

Reply to "Wiring of the Lionel 610-8057-200 Smoke unit."

On the 3 pin feed connector to the 8057-200, the outside 2 pins should be jumpered together at the connector. One side is hot to the heater and the other side is feed for the fan motor 5 volt dc circuit. The middle pin is chassis ground. So just one hot wire to the ERR P & C. You can BTW jumper the 2 outside pins on the solder side (top) of the SMU circuit board if that's easier.

Rod

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×