Skip to main content

Reply to "Wiring Schematic for Lionel #38053 L2a Mohawk..."

gunrunnerjohn posted:

Actually, with no serial data, the symptom is normally it takes off at full speed as soon as you crack the throttle.  Check the 4-pin connector from the motherboard to the CC-M.

I only see two wires in the PWM connector, so you have no 5V to activate the opto-isolators, that's your problem.  This connector should have four wires 1:1 from the motherboard to the CC-M, I think that will fix the problem.

You have no power to the input optos.

 

The harness with the new cruise m comes with a 3 wire set up for J1. 1, 2, and 4. 

Last edited by SPFord27

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×