Skip to main content

Reply to "Wiring / Set-Up Question for Legacy Command Control to DCS TIU"

1. Connect wire from Command Base to "Black" fixed Output of TIU.

4. Connect "red" Fixed Output 1 to center rail, "black" Fixed Output 1 to outside rail.

5. If you are running conventional you need to power the TIU via a separate power supply or run jumpers from Fixed Input 1 to Vari Input 1. In addition, use Vari Output 1 not Fixed Output 1. If you are running everything command then initial set-up for the TIU is correct.

 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×