Tony H posted:I use the DZ 2500 on all my switches and also use the CSM2, but don't use the break out board. I already had the 1008 installed on two switches before I added the CSM2 and did not make any changes and it still works. I did not see a reason to add the breakout board.
Tony
Tony H posted:The only thing I did when I added the CSM2, and I added 7, was attached the blue wire to to the CSM2. I had the switches set up for a few years before adding the CSM2s
Tony
So basically you replaced the DZ-2001 Data Driver with the CSM2. For sensing, it seems like you need to run either the green or yellow wire to one of the CSM2's switch positions. It is that simple? Here is what I think the wiring diagram would look like:
I'll set this up soon on my test loop.