Skip to main content

Reply to "With Gargraves flexible track how big a gap do you allow at a joint?"

Like most here, I try to close the gaps, but at a few places - on or at the end of curves usually, there ends up a pretty big gap.  In those cases I cut a piece of rail with a cutoff disc, the length of the gap.  I then just slide it over the exposed pin and squeeze it closed.  I then solder it to the adjacent pieces to keep it in alignment with them.  Fortunately, I think I have only three or four of those replacements

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×