Skip to main content

Reply to "Worm gear removeal"

The supplied stepped shaft will not go far enough down into the gear to make contact with the armature.  The roller pin is what makes contact.   Order = Armature-Roll Pin-Puller Shaft

I will drill a hole in the supplied shaft that will accept the roller pin to make it a little more precise.  For now, it works.

Last edited by David Minarik

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×