Skip to main content

Z stuff

I have been trying install my crossing gates and block signals.  I think that I have wired them up correctly and have tried to follow the directions as best I can see. I did have it partially working, but it wasn’t working the way I -expected. I reconnected again, and soldered the connections and tried to make sure I had everything lined up properly. But this time when I powered it up, I got a completely unexpected result. One of the gates went down , and the other kept raising and lowering repeatedly and would not stop, unless I interrupted power.



I am attaching photos of my connections, and a video of what happens when power is applied. I would greatly appreciate it if you could take a look at these photos and see if you can see where I have gone wrong. I have ordered additional z stuff signals, and need to get clear on how to install these signals soon.



Bill Toomey

925-503-9781

train crossing 1

Attachments

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×