Skip to main content

Reply to "Z4000 IS NOT WORKING ."

Greetings Antonio,

There is a repair thread for this on the forum. It has some diagnosing tips and had photos of the board and the devices to that need replacing. If you can solder reasonably well, you can repair it. it's a 2.5 or 3 mm hex wrench to remove the case screws.

Contact forum member GGG by private email for assistance. You should be able to send him just the control board for repair. Perform an Advanced search, select member search and use GGG as the search parameter. Open the profile to find the email address.

if I find the thread, I'll post it. I haven't located it yet.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×