SlUGGER- I have this system and LOVE IT. Many good guys on here just have their own preferences. NOW - First of all, disconnect from layout for testing purposes. Command mode -(NOT in super ZW mode) All 4 bricks plugged in to the ZW. Legacy base connected to common on the ZW-All handles forward-Power on to Base and ZW- Channels B and C should immediately come up to 18 V. You should have to manually dial up channels A and D to 18 volts with the Legacy remote. Verify all output voltages on A-B-C- and D with a VOM. If you are not getting these voltage readings and you have preformed the "potentiometer re-set" AND made sure that the out put voltage on the bricks is in fact 18V, then you have an internal issue. However you are not out of luck by any stretch. Even if parts are not available. Send me an e mail if you can't get anywhere.I can offer a plan B solution. Good luck. Nick
|