Lou1985 posted:CoastsideKevin posted:Ok, I think I’m close to figuring it out, and I believe the problem is not with the ZW. The accessories wiring is led underneath the track near a point where the A loop wiring connects to the track. I think when I was running two trains hard, that section must have heated up enough to melt the insulation on the accessories wire and it came in contact with the track.
I know this wiring looks crude but it is temporary while I finish the layout. This was the run and when I pulled it up, bingo, continuity gone.
So obviously I need new bigger wire for the main accessories run to the bus - any further thoughts on how to prevent this much heat from causing further problems? Is this a common issue that everyone contends with?
Thank you all so much for your help. This forum is awesome!
Get a second transformer for the accessories/lights.
Minimum wiring size from the track to the transformer should be 14 gauge. I'd use 16 gauge minimum for accessory wiring with smaller feeders (20-22 gauge) to the individual accessories.
Edit: Also have multiple power feeds to the track. One feed per track loop is not enough.
Yep, will do that. I am using 14 ga for all track connections, several per loop (every 15 feet or so), but my accessory wiring is too small. Will change that out.