Skip to main content

Hoping you all can help me out with an American Flyer 561 that I just can't get right.  At this point I have 2 "running" motors.  The problem is that I have one set of side rods that connect the 3 wheels, and no matter how many times I try to reset the position of the wheels they want to bind of the rods.  This happens on both the motors.  I've tried so many times that I've actually started destroying the wheels pulling them off and putting them back on.  Since I'm going to run out of wheels soon I need some help.  I've seen jigs for the purpose of quartering the wheels and lining them up correctly.  I of course dont have access to that.  I simply pull the wheels with a wheel puller, align them on the side as exact as I can, and press back on.  By eyeing them, they look perfectly aligned, but when turning the motor they will bind on the rod.  Is there a trick to this that I'm missing?  Perhaps the rods I bought off ebay are the incorrect ones?  Pictures seem to match what I see on other 561 exampless...

Any tips would be appreciated.  I've restored 50+ postwar Lionel and Marx, but this is my first work on an American Flyer, and it might become the first train I've failed to complete.  Frustrating!

Last edited by Loochy88
Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×