Skip to main content

The MTH instructions say the signal man operation on this caboose (no. 20-91636) can be triggered by holding down the bell button on your transformer or on your DCS remote for 1-2 seconds. I'm trying to run it with a LionChief Plus engine. The bell button on the LC+ remote doesn't activate the signal man. I also tried it with a conventional transformer, but it doesn't have a separate bell button, only a whistle button. Pressing that doesn't do anything, either. I don't have a DCS system.

Does anyone know any magic method to activate the signal man in this case? Or will it be necessary to get another transformer with a separate whistle button? Thanks.

Original Post

Replies sorted oldest to newest

Thanks for the suggestion. In checking this out, I found this additional information as shown below. Good to know if anyone else is in this situation. The switch to use is a different one from the 5904 for all but those using a MW transformer. Most operators will want the #10-5906-001, it appears.

Hopefully this will work, but I'll also be interested to try using it in a 18v Lionchief environment.

CAUTION:  DO NOT connect this switch (#10-5904-001) into a common ground layout. This #10-5904-001 switch is intended to be used only with Lionel Type MW transformers and Railsounds locomotives and boxcars. The Type MW uses the #10-5904-001 switch, which reverses track polarity when activated.


All Lionel transformers except the Type MW are common ground transformers and can use the #10-5906-001 switch which is different from this switch.

Last edited by breezinup

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×