Skip to main content

I don’t do much DCS operating, but thought I’d try DCS with the WIU to run the LCT #8 and #9 LCT trolleys (both are ps2). I can’t get the App to “add” the engine, though. It works great in conventional mode, but can’t add it in DCS. I can add other engines, no problem - Just these. I feel like I’m missing something very obvious. Any suggestions?

thanks for any help,

Andy

Original Post

Replies sorted oldest to newest

Sorry for my delay....

just for confirmation, the trolleys I’m trying to run are 11-2025-1 and 11-2026-1.

I’m using the app - no remote. And I’m on my under-the-tree layout (still needs to come down!). 
My engines that connect to DCS no problem show strong DCS signal strength in the app. 

I replaced the MTH battery with a BCR and ran it for awhile in conventional mode to confirm operation. Shut down test confirms good BCR.
Switching over to DCS, the app still cannot find the trolley. I can add other engines, but the app cannot find the trolley at all. 

Could it be that these engines do not operate in DCS mode despite being PS 2?

next thing will be trying this on a test track

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×