Skip to main content

A friend bought a 1991 Lionel F3 A-B-A War bonnet set (6-11711) from a SoCal hobby shop (now gone) about a decade ago. The powered A had two AC Pullmor motors and an e-unit   as TMCC was yet five years away. The shells are still pristine, so we suspect they were old/new stock. Oddly, someone, perhaps the store technician, had upgraded the powered A to TMCC with an ERR (2008) Rail Sounds AC/DC (or AC only) Commander. It all ran well until recently when the motors quit working. Everything looks OK, and all sounds work properly. Response to a reset was normal, but the motors did not awaken. The Diesel roar rev’s up and down with the throttle knob, but no motor response ( not even a hum to indicate the motors are trying). Seems as if a motor driver blew, or the thing got locked into neutral. Anyone out there have the key? 

Original Post

Replies sorted oldest to newest

RoyBoy - all seems tight; no smells, no burnt spots visible, except that I hesitated dismounting the mother and radio boards from the fuel tank cavity to examine their undersides. I'll have to do that, I guess. 

LOU1985 - Sounds come on when conventional track power (sans command box) is applied. With TMCC present, sounds come on only when engine is addressed. 

Thanks to both of you!

It's pretty easy to test the motors independently by just wiring the field coil to one brush, and the other brush to the center rail.  The other end of the field is frame ground, so that should spin the motors.  If that works, you need a little repair on the AC commander, likely the Q4008L4 triacs have been toasted.  They're cheap and readily available, not a difficult repair.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×