Skip to main content

Hi all,  Recently had a problem with 6-11149 Big Boy. This is one of the early Legacy versions.

I wondered if anyone had come across the same problem. 

The loco was jerking/running at uncontrollable speed for short bursts. 

I checked over the wiring and reseated connections. Checked the encoder ring. However the fault continued.

I then disconnected the smoke unit and the loco ran fine when tested.I opened up the smoke unit and found it was quiet chard and the batting pad was burnt on to the element. 

I had a spare element and some of the new style wick material. So I replaced those and reassembled it. Much to my surprise this appears to have fixed the problem

Would a smoke element going bad cause a short that would cause the loco to apparently lose command signal?

Thanks for any input.

Nick

Last edited by Nick12DMC
Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×