Skip to main content

The engine in the photo is CVRR #81, effectively a PRR narrow Belpaire boiler H6 2-8-0.

But just what is that car out in front of it??  I had a passing thought that it might be some sort of clearance car and that the long "white" bar linked to the pointed bit with the ball at the end might swivel out from the side of the car?  I can read ....LING C on the side.  Poling car?  Thoughts?

Original Post

Replies sorted oldest to newest

Martin, that is indeed a poling car and it is used for moving cars on the track adjacent to the one the locomotive is on.  The white pole is supported at a height that matches up with poling pockets on the car ends and it is pivoted in the middle so that it can pull or push a car on the next track.  Using a poling car was much less dangerous than having a brakeman hold a loose pole in between the loco and car.  PRR had quite a few of them back in the day.

Last edited by Bob
Bob posted:

Martin, that is indeed a poling car and it is used for moving cars on the track adjacent to the one the locomotive is on.  The white pole is supported at a height that matches up with poling pockets on the car ends and it is pivoted in the middle so that it can pull or push a car on the next track.  Using a poling car was much less dangerous than having a brakeman hold a loose pole in between the loco and car.  PRR had quite a few of them back in the day.

Excellent!  There are so very few photos of anything but engines for the CVRR that anything else in a photo is something rather special. 

I would not have thought that the pivot for a pole in the middle of the car would have been strong enough for this purpose, but then that's something I've learned now.

Ok it looks just like a PRR SA class poling car! 

http://prr.railfan.net/diagram...ll&sz=sm&fr=

Now, I can actually build a model of this car.

Last edited by mwb

Marty,

The car in question is a PRR class SA poling car with a center pivot point so the pole can be used in a forward or reverse movement. The pole pivot was a bracket attached to the car side-sill with a control rod extending up to above the car deck for manual alignment. 

In Wayner's 1969 book Pennsy Car Plans there is a drawing of a classs S-5 car with a similar poling mechanism but a larger crew cabin. the car is 25'-6" over end sills  and has 14'-6" truck centers with a 5'-6" wheelbase.

Now you can build two.

Buzz

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×