Skip to main content

I have seen first hand with other people's locomotives that are Legacy, they won't back up. Today I received my Class A back from Lionel for the 6 time, fixing some sound issues and speeding bullet takeoffs when the whistle is blown.

These got fixed but now my Class A wont back up. I tried a factory reset and it did nothing. Now for a diesel such as bigdodgetrain's BNSF ES44 when in lash up with the Warbonnet unit it won't back up.

Now what causes this and is there a way to fix this?

Original Post

Replies sorted oldest to newest

Not sure if this will help or not, but I recently had an issue with a Legacy engine going forward just fine, but when I tried to reverse direction with the Cab 2 remote, it wouldn't work.  It kept going forward.  For me, the culprit was that I had a slight break in my Fastrack.  Once I found the slight break and tightened the connection, all started working correctly again.  Good luck!

If upside down and one motor works and the other does not, either a lead to the motor is broken (insulation can hide the break), or the motor is bad, or gears are bound (grit, dirt, misalignment, bend).

If neither motor turns you back to the motor driver board, or the wire connection at the board, or the Radio receiver.  For the new Legacy it would be the main board, harness, or receiver.

Test in conventional to help isolate, as sometimes a board works one method and not the other.  That would help eliminate motors and wires.  G

GGG posted:

If upside down and one motor works and the other does not, either a lead to the motor is broken (insulation can hide the break), or the motor is bad, or gears are bound (grit, dirt, misalignment, bend).

If neither motor turns you back to the motor driver board, or the wire connection at the board, or the Radio receiver.  For the new Legacy it would be the main board, harness, or receiver.

Test in conventional to help isolate, as sometimes a board works one method and not the other.  That would help eliminate motors and wires.  G

took off both trucks in a non command mode neither will go into reverse.

 

thought it was only one but it is both that will not reverse.

engine revs up like it is moving and then the flash of the cab lights for engine (1) start. 

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×