Skip to main content

I posted this elsewhere and might have got buried, I  apologise to those that read all posts - I have a DCS Commander so I hooked that up, the locomotive is found and starts up, however it won't run. I just have it from DC Track power output to my track and put in DCS command mode but the loco won't move. I did try a couple of different locomotives and switching the cable around. So I'm wondering if it is in fact the TIU or something else? If I hook the track directly to the z-4000 it will run locomotives fine. I did search the site last night and read thru the forums for some help but couldn't find this particular problem and the DCS manual is pretty limited. The software on all my equipment is at least one year old, possibly more like 18months and I was reading they did a software upgrade to address this type of issue?  

Original Post

Replies sorted oldest to newest

Is it possible all locomotives would be in neutral? I have five or six locos and none will run. Is there some setting on the Commander that will cause this? I see it can be tricky (from searching posts) to do a reset. I vaguely remember years ago having the same issue. I don't see how this would affect all locos though? I previously operated all locos with the handheld remote before my TIU stopped working, is there something on the handheld that would have affected all units?  

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×