Skip to main content

If I am trying to run both DCS and TMCC engines under one TIU(I.) and a TMCC Base with the MTH App; which Wifi mod do I need Lionels or MTHs?? Do I need both??

And how do I connect the TMCC Base Unit into the mix, I think I need a SER2?

What does the wiring look like?  It's not in Barry's 12 page Addendum or the WiFi companion that never talks about the MTH WiFi Unit with the Lionel WiFi.

Can't imagine why you would need two WiFis for one TIU and a TMCC base that talks to the TIU.

Confused??

Original Post

Replies sorted oldest to newest

lan,

It's not in Barry's 12 page Addendum

Look at the following on page 3 of the addendum:

Wiring for TMCC Engine Control (Only)

The following wiring methods allow control of TMCC engines, and Legacy engines that are configured as TMCC engines.

Then, look at the diagram on page 3.

The WIU is not shown on any diagrams because it is always required.

Last edited by Barry Broskowitz

Alan,

thanks  i see how the Explorer TIU WILL MAKE THIS EASIER

It will make things easier because it won't allow either full DCS features and functions, , accessory or switch track operation,  or use of TMCC/Legacy engines at all from the app.

The DCS Explorer is not a replacement for a TIU/WIU combination. It is only intended as a DCS entry-level device.

Last edited by Barry Broskowitz

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×