Skip to main content

I wired an operating Passenger Station to an AIU, following the steps/diagram of the DCS Companion. When I activate the station via the AIU, the platform raises partway and immediately drops back down. After checking & rechecking the wiring, I deleted the station and re-attached it to a different accessory output of the AIU, same problem. I then wired the same station to the Manuel switch, works fine.

any ideas from folks is appreciated! Power is from a Z4000 14 volt accessory output.

thanks

Original Post

Replies sorted oldest to newest

Brice,

My DCS is currently at 6.10, so if a person happens to miss one like I did several years earlier - the latest upgrade won’t catch you up? 

You can skip any DCS upgrade and go from the oldest directly to the newest without any ill effects. However, if you go from any DCS 2.x release to any DCS 3.x or higher release, it's mandatory to reset both the TIU and the remote directly after doing the upgrade.


DCS Book CoverThis and a whole lot more about DCS is all in MTH’s “The DCS Companion 3rd Edition!"

This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at MTH's web store!

DCS Book Cover

This and a whole lot more about DCS WiFi is all in MTH’s “The DCS WiFi Companion 1st Edition!"

This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at MTH's web store!

Get the free TMCC & Legacy Addendum here!

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×