Skip to main content

Replies sorted oldest to newest

There’s something about speed step 23. This sounds ridiculous, but on my scale Lionel B&O F3 the engine would run fine for several minutes at step 23 and all of a sudden it would stop. When I backed off to step 22 it started moving normally. Mike from Lionel said to just replace the main board but at $100.00 I decided it’s cheaper to just bypass step 23 and go right to step 24 or 22. After several months running like this I was cleaning the wheels and noticed one of the rollers had a small bind to it. I oiled both the rollers and has now been running at step 23 for several years perfectly. I just have no explanation for this other than electronics and AC trains can have unexplained gremlins hiding within.

Lagerstout posted:

Actually somehow in the past 24hrs the issue resolved itself when I ran the engine this evening.

Usually when a symptom "resolves itself" that is not really what happened. It's an intermittent thing. If you did not find what was causing it, the behavior will happen again.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×