Skip to main content

Hello I recently received a box of Marx, Lionel and A.F. signals and devices. One of these is a Marx circuit breaker. There is one wire going to an insulated post. one ground terminal, and a third wire hanging down unattached. Were these effective as a circuit breaker? I know very little about Marx and was looking for information about this

Thanks

Mark20180726_203633

Attachments

Images (1)
  • 20180726_203633
Original Post

Replies sorted oldest to newest

   They worked. But I don't recall how exactly.  I think there should only be a hot in and a hot out for this #420 and Lit if on. The third leg would likely go to common. Especially if modified to light on point break. Can you get inside and describe what's seen or take a picture to tell for sure ? It wont be hard to figure out. (Assuming nobody else has a fast answer)

It is a thermal breaker.  It can be checked for operation with a direct short and a count to ten. No more or less effective than any other thermal breaker from Lionel or in the power seats of the car you drive today. If it is in good shape and wasn't overheated to the point of abuse it will do the job it was made for.

There are better options today sure. Mostly IN modern transformers, but this is not useless and too dangerous to consider using just because it's old. 

Mark Wags posted:

Thank you for all of the information.  I know so little of Marx and was curious as to how this operated.

The third wire is probably for the indicator light.  Basically, the breaker works thermally, with the light wired in parallel.  When there is a short circuit, the thermal breaker heats up and opens.   At that point,  power goes to the light instead, and it lights up.  

I wrote an article on Lionel and Marx breakers for the CTT forum back in 2014, but what with Photobucket getting hinky, it no longer has pictures.   I'll see about reposting it here. 

Mitch 

My grandfather wired one of these in between track and transformer on the plywood sheet layout he gave me in the 1940's.  Immediately after l got it, l derailed the train and got a short.  Train wouldn't run. Later in the day he came by and said, "Push the button!".  Worked great with one of those vertical Marx transformers with the easy to move rheostat lever.  How come, on the later horizontal Marx transformers, you almost need a locking pliars to move the lever?

The last two accessories are 407 Automatic Crossing Signals.  Marx used the square base for a number of accessories and the top used on the circuit breaker is also used on the 407 Automatic Crossing Signal and the 605 Illuminated Bumper.  Just different lettering on the face.  Since the tops are interchangeable they are often incorrectly put on the wrong base.

 

Don

I had one of those Marx circuit breakers on my childhood O27 Marx 999 engine layout that worked great.  I opened the CB and saw how it works.

Below is a photo of my control panel Marx copied circuit breaker shown on top.  The "Reset" red circuit breaker button on a $3, 6 amp circuit breaker wired in series to one of my Lionel LW transformers.  The red lens over the "Short" hides an 18 v light bulb that us wired across the two contacts of the CB.  When a short occurs, and the CB opens, power is cut to the trains and all the power to the track goes to the bulb and indicates in red a short has occurred.

This works great for my conventional control, post war O27 layout which runs mostly Marx and Lionel trains.  I have no modern trains with newer less rugged electronics that may require faster working protection.

 

Train Lots 5-10-2016 251

I have three such circuit breaker for my 3 Lionel LW transformers and been using them for over 40 years.  I uses these 6 amp circuit breakers for two lighting circuits and a switch operating transformer.  I do not need to put a light across the CB contacts as I can tell when they throw (lights go out and switches do not operate).

Charlie

Last edited by Choo Choo Charlie

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×