Skip to main content

Hello,

 

I just received via Fed-X a Lionel 18" Aluminum Stations Sounds Car (6-25419).  There were two loose tables rattling around inside. I was able to get them out with removal of the car ends.  I thought I would glue the tables back in place, however, I can't figure out how to remove the shell. The shell will slide each way about an inch until the trucks hit on the side skirts.  Do I need to remove the trucks? If so how?  It looks like there is an e-clip holding trucks on but not an easy way to get at. I was trying not to remove trucks since it's a sound car with extra wires. 

Thank You!

Doug

20190112_164512_006

Attachments

Images (1)
  • 20190112_164512_006
Original Post

Replies sorted oldest to newest

This is a Station Sounds diner. Its been awhile but I believe this one and the Post Office car made blast out plenty of profanity. 

If my memory serves me correctly, you need to disconnect the lights and boards in order to slide it out, I believe there is a ground wire too?...one of my boards kept hanging up on the car walls too. Not fun.

Oh and those blasted bulkhead walls will hang up too. Good Luck.

Last edited by J Daddy

Thanks everyone for your help.

I looked at the masking tape idea but there just is not enough room for the trucks to pass by the skirts.  I did figure it out. If you remove the underside detail (die cast) and the 4 screws under the trucks, the bottom plate (frame) will drop down just enough to slide the car interior out one end of the shell. When all is assembled, it looks like the frame is inside the shell channels. Not the case...all good now.

 

Thanks again!

 

Doug

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×