Skip to main content

Replies sorted oldest to newest

Robert, I want to make sure I understand. From what you just said and what I've gathered from past discussions. you have the following:
- 1 LT O72 switch
- 1 RT O72 switch
- 1 LT O48 switch
- 2 RT O36 switches
- various other straights and curves???

I believe you also said at some point that you don't want to buy any more switches. Is that all correct?

If so, here's what I see you working with as far as switches go.

2019-03-26 daz

 

Attachments

Images (1)
  • 2019-03-26 daz
Files (1)

Sorry, but given the limited number of switches and O72 ovals, I'm not coming up with much. There aren't enough switches to make a double crossover, so that means that once you go from one oval to the other you can't go back without backing up or at least reversing the engine. It's the same with only 1 reversing loop. If you're running diesels that's not so bad, but steamers will be more difficult.

2019-03-26 daz

2019-03-26 daz 3D

 

Attachments

Images (2)
  • 2019-03-26 daz
  • 2019-03-26 daz 3D
Files (1)

Okay, Robert, here's a clean version of you buy the 2 O72s and 1 O48 switches. I noticed you didn't include the O36 switches.

As I'm sure you'll notice, I moved the crossovers to the corners on the curves. This will let you run faster speeds and transition through the crossovers without any hint of "S" curves between the switches. You still have the problem of only 1 reversing loop, but at least you'll be able to transition back and forth between mainlines.

2019-03-26 daz-a2019-03-26 daz-a3D2019-03-26 daz-a-clear

Attachments

Images (3)
  • 2019-03-26 daz-a
  • 2019-03-26 daz-a3D
  • 2019-03-26 daz-a-clear
Files (1)

If this is the design you built, the outside Blue line is just over 504". A catenary set with 8 poles/wires is 160" and a set with 4 poles/wires is 80".  Therefore you'd need 3 sets of 8 and 1 set of 4 to give you 560". However, if you added the Gold spur, it's another 120" making the total 624" and you'd need 4 sets of 8 to give you 640", assuming you want to cover both the Blue and Gold lines. I think the calculations are correct, but I could be mistaken.

test

 

Attachments

Images (1)
  • test
Robert Cushman posted:

also what is the distance between posts on the catenary?

Well, the wires are 20”, so on the straights the posts would be 20” apart. However, because they’re outside the outer ring, the arc will be a little larger than the center rail of the tracks, so they’ll be a bit further apart on the curves, but it won’t be by much.

Add Reply

Post
The Track Planning and Layout Design Forum is sponsored by

AN OGR FORUM CHARTER SPONSOR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×