Skip to main content

I have a Mi Jak container crane and it stopped raising the containers.  Upon further inspection I've found a gear that has split parrell to its axle shaft, does anyone know if these parts are available, and if so where can i find it. 

I have removed, cleaned and CA glued the gear back under clamp, however im afraid its likely to split back open when re-assembled, due to the lobe on shaft.  Id much rather replace it.  Any help is appreciated as this is a fun piece to operate

Original Post

Replies sorted oldest to newest

Glue the gear back together. Then use an appropriately sized drill bit to carefully enlarge the hole for the shaft. Don't go too big! The gear should fit snugly, but move easily on the shaft. Epoxy it in place. That will hold you for quite a while. Or you can pick up a metal one as GRJ has suggested.

BTDT.

 

Chris

LVHR

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×