I need a little help. The e unit fell apart during a little maintenance and o e of the wires fell off. Does anyone know where it goes? Looks like it could go on either of the fingers. Thanks in advance
Those bottom fingers are shot, need to replace those. Is that the power wire from the pick-up? If so it goes to the hot side of the E-unit, opposite lever ground contact.
Yes, the loose wire does go to the center rollers. I assume the picture above would be correct and I need to solder the connection again. I will try tomorrow. Thank you for your help and guidance. Gotta get this old girl running smooth again.
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
Access to this requires an OGR Forum Supporting Membership
OGR Forum Supporting Membership
Help support this forum with an OGR Forum Supporting Membership. You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM! A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!
OR
Access the ALL the OGR VIDEO FORUMS ANDover 300 back issues of OGR with a DIGITAL SUBSCRIPTION!