Skip to main content

Replies sorted oldest to newest

All this information is in your Manual received at training, no?  Parts go in and out of stock.  Boards can be ordered separately or as a set.  But if they do not have the individual, they may not want to breakup set depending on inventory level.  Frankly it is rare for a top board to go, but I have replaced the speed amp and a light fet on occasion.  G

order: AE-1000035-5V PS3/2 board w\ 5 volt adapter board.

           IC-0000026 Hardware mounting kit: and if 50mm speaker

           BF-0000034 4 ohm speaker. 

This is all you need to convert ps-2 5volt in diesel or steam with board in the tender. If the board is in the boiler then some very imaginative engineering to mount the board is in need. I have seen a steam loco with the new board held in with rubber silicone. Not sure I would have done this.  If the board is in the boiler it may be better to use the PS-3 Steam upgrade and put the new board in the tender. 

I am an ASC tech. and Authorized Service Center. 

 

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×