Skip to main content

As my layout grows, so does the current demand.  I have been using a Lionel "VW"  (150W) for track voltage, eight #O22 switches, and six #6019 remote control track sections.  I installed TVS on each leg of the transformer plus a 5 amp circuit breaker for track voltage.  With this set up I do not trip the circuit breaker in the "VW".  I do know that it works.  I run my accessory lights with a CW-80.  I suspect I'm reaching the limit of my "VW".  I also have a Type "S" transformer available.  Should I move the switches or control track to the Type "S"?  I'm aware of the need to keep transformers in phase.  Which one should I move?  I have a second 5 amp circuit breaker installed but unused on my control panel.  I run conventional and LC+ locomotives.

As always, thank you for sharing your wisdom.

Bill

Original Post

Replies sorted oldest to newest

To reduce the power draw in general, I picked up some Direct replacement LED bulbs (available with the various bases with resistors already built in) and swapped them out on all my 022 switches and bumpers as well as my 2500 series passenger cars and the difference was quite noticeable.  Look for the "warm white" or "soft white" and it pretty much looks the same

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×