Skip to main content

Bought a Lionmaster Challanger on ebay last month and when I recieved it one of the green marker lights is out.  Tested with a multimeter and it is getting power.  Does anyone know where I can get a replacement...Lionel doesnt seem to have the part# on their site.  Im guessing I'll need to order one from an electronics parts site.  Anyone know the size and voltage?  Any help would be much appreciated.

Thanks, Front Green Marker LED

Attachments

Images (1)
  • Front Green Marker LED
Original Post

Replies sorted oldest to newest

Well I received the new LEDs from Lionel today and installed them...only to find out the same issue persists.  Does anyone know the voltage outputs of the 2 conductors that attach to the 2 green LEDs on the 6-82694.  When the marker lights are turned off via the Legacy controller...the reading between Ground and each conductor is 7.8v....when activated I'm seeing 2.8v on one conductor and 7.8v on the other.  I know the LEDs will activate only with the proper voltage.  Im guessing there's a logic chip that routes the voltage thru a resistor when turned on.  Its looking like an issue with the main board now.  Any suggestions before I rip this guy a new one for selling me an engine with a damaged board.  Im seeing on the Lionel site that the 691RCMC657 board is $120 (if they have it im guessing).

First off, the LED voltages are referenced to DC ground, NOT frame ground.  You need to verify if the LED's will both light if you power them from an outside power source.  A 9V battery with a 1K series resistor will light the LED's, see if you can make that happen.  It looks like the LED's might plug into a wiring harness before they get to the RCMC, did you check continuity of all the wires up to the RCMC connector?

The green color is incorrect for the classification (not "marker"; the markers are on the tender) lights on the front of a locomotive unless there is a second section of the same train following.

Classification (and loco marker) lights were almost always turned off, so you really should unplug the "good" one.

     Thanks for the info guys...after some further testing...turns out not only did I have 1 bad original LED...but the set of LEDs I got from Lionel had 1 bad one as well...luckily I ordered 2 pairs(you know..cause you never know).  I attached the second pair and they both lit up.  Man was I relieved and sorta upset w/ Lionel.  So I installed the good pair and cobbled the 2 good single LEDs together to make a second working pair...so I guess it all worked out anyway.  But geez...a bad LED right from Lionel...not cool Lionel.  

D500 posted:

The green color is incorrect for the classification (not "marker"; the markers are on the tender) lights on the front of a locomotive unless there is a second section of the same train following.

Classification (and loco marker) lights were almost always turned off, so you really should unplug the "good" one.

So if he only has one green light does that mean that is only a half of a second section following?

Gene Anstine

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×