Skip to main content

I need to find several of the all-nation ball joint kits to replace broken ones on some used units I recently purchased. Anyone have any or a source for same. I'm also open to other suggestions. I would like to continue to use the original motor and gear boxes.
Any help appreciated.
Leon Butler

Original Post

Replies sorted oldest to newest

Opinions abound.

 

I use the NWSL part on the end of a hunk of Toyota #0 hose, Plastic on metal is a much better way than brass on steel - brass is one of the poorer materials for such applications.  All Nation provided a plastic tube, and others have had good luck with it.

 

I tie all my motors in place with aircraft safety wire, usually with a sandwich of rubber to deaden the noise.

Just to clarify, I had a broken ball joint on the motor shaft and the other half of this coupling was some type of plastic, hence no possibility of a short. This was an early A-N version before they used the plastic tube to connect the motor shaft or the two power trucks. I'd still like to find some original ball joints if anyone knows where to find them when and if my solution fails in the future. I did find the motor mount grommets at Lowes locally.
Leon Butler

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×