Just picked up the most recent version of the greenbrier and this draw bar gap isn't going to cut it. Thankfully MTH makes the draw bar kits however I see they make two different length kits. I'm not really sure which to go with. I plan on running the engine on only 0-72 minimum curves and I'd like the closest possible gap. Any recommendations on which length kit to go with. Anyone have any experience with doing the same mod to this engine or similar? Thanks.
Replies sorted oldest to newest
You can go as small as your layout curves allow. Lots of 2R guy like them very close, but they run on much larger dia curves. G
anyone have the part number for a 35mm draw bar mth for 20-3415-1e big boy engine ps 2 3 volt engine.
any help would be appreciated could not find on mth web sight
Alan Mancus posted:anyone have the part number for a 35mm draw bar mth for 20-3415-1e big boy engine ps 2 3 volt engine.
any help would be appreciated could not find on mth web sight
I believe this is it. If yours has the circuit board built in correct?
if this is it the product # is FB-0000007. Or you can buy them in a 3 pack #20-89011
yes I found the FB-0000007 but not in stock at mth costs $10.00 the20-89011 is a 3 pack but costs $29.00 3 different sizes are included . I was hoping someone has the FB-0000007. will call mth today if I don't hear from someone on the forum having it! the 20-89011 comes with a 30mm 35mm and 40mm draw bar
thanks for any help you can provide!
Access to this requires an OGR Forum Supporting Membership
