Skip to main content

Just bought the license for Anyrail and am having a great time using it, however I can't seem to find how to cut or shorten a piece of track. I manage to get the pop up menu with the "knife" icon and "cut flex here" command, but cannot figure out how to use it. Cannot find help in the on-line manual. Would greatly appreciate any help.

Thanks, Steve

 

 

Original Post

Replies sorted oldest to newest

Steve, I have used the "cut flex here" command.   Basically, you add a piece of flex to the layout, then position the pointer over the location you want to cut, and it cuts the flex into two connected pieces.

You can also work with flex pieces after added to the layout:  you can select the end of a flex piece and lengthen or shorten the piece with the mouse.   Hard to describe better than that, just try it if you have not already.

Add Reply

Post
The Track Planning and Layout Design Forum is sponsored by

AN OGR FORUM CHARTER SPONSOR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×