Skip to main content

See the photos, this is the front of the Lionel 2031160 Santa Fe Northern. The tolerance between the cow catcher and the middle rail is less than the thickness of an index card. Frequent shorts are the result. Has anyone else had this issue, and is there a way to re-position the cow catcher? 

Attachments

Images (2)
  • CowCatcher_1
  • CowCatcher_2
Original Post

Replies sorted oldest to newest

@VegasTrains posted:

See the photos, this is the front of the Lionel 2031160 Santa Fe Northern. The tolerance between the cow catcher and the middle rail is less than the thickness of an index card. Frequent shorts are the result. Has anyone else had this issue, and is there a way to re-position the cow catcher?

Pilot probably go knocked askew in shipping. I have one of the locomotives from that run (2031170, road number 3759) and the screws holding the pilot are barely long enough to secure it. Flip the locomotive over, loosen the screws holding the pilot to the chassis, bend the pilot up so it clears the track, tighten the screws. Problem solved.

I can tell the pilot on your locomotive is loose as the handrail on the engineers side is out of the stanchion on the pilot.

Last edited by Lou1985
@Lou1985 posted:

Pilot probably go knocked askew in shipping. I have one of the locomotives from that run (2031170, road number 3759) and the screws holding the pilot are barely long enough to secure it. Flip the locomotive over, loosen the screws holding the pilot to the chassis, bend the pilot up so it clears the track, tighten the screws. Problem solved.

I can tell the pilot on your locomotive is loose as the handrail on the engineers side is out of the stanchion on the pilot.

Lou, is the hand rail the antenna too??….boy if it is, the OP will be in trouble with a shorted out antenna soon?…..no??.

Pat

@Lou1985 posted:

It should look like this. Plenty of gap between the pilot and rails.

20220118_21514120220118_215119

Also make sure the handrails are in the stanchions like this.

20220118_215226

Screws holding the pilot are here. You'll have to remove the boiler to access them.

20220118_215702

From the Photo's, it looks like you have plenty pr normal clearance,  use a piece of clear tape under the pilot, then  go over you track , with a plastic level to male sore its not your tube track!   A hump on the middle rail. You are running a precise model, over a  track product that never was!

From the Photo's, it looks like you have plenty pr normal clearance,  use a piece of clear tape under the pilot, then  go over you track , with a plastic level to male sore its not your tube track!   A hump on the middle rail. You are running a precise model, over a  track product that never was!

Yeah my model is fine. I posted the pictures so the original poster could see how his is supposed to look. The original poster's model has the pilot too low, not mine.

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×