Skip to main content

Replies sorted oldest to newest

The "direct" fit is the atlas scale coupler. You may need a spacer to get the height right. There is a pilot insert on "that 3D printing site", but the height of that probably assumes you fix the pilot to the frame.

A kadee will fit if you use 2mm screws, the back screw needs to be run in at a slight angle to get it to bite in the hole.

So that's my fault not looking at what forum I'm in.  If its the Atlas TMCC 2 rail model with the electrocoupler, then it would probably just accept a standard atlas 2 rail coupler and box without work.  You could try the SW insert, and it probably would work with either rail count, since the kadee height is standardized from the rail head (there is a pilot spacer associated with the insert to get the pilot height correct when you fix it). Since the lid of an atlas box is a bit thicker than the lid of a kadee box, you may need to put a shim inbetween the pilot and a kadee box, but a little experimenting would probably get it.

Last edited by Boilermaker1

Add Reply

Post
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×