Skip to main content

Replies sorted oldest to newest

I used needle-nose pliers to bend two horns back into place.  I first covered the plier jaws with electrical tape so I would be less likely to scratch the horn assembly.  I applied a small amount of torque and the metal slowly bent back to a more normal position.  The amount of force needed was below any concern over damaging the plastic.  I purchased the F-3 set on eBay and they arrived today.  I've attached before and after pictures for the two bent horns.  Tom



Images (4)
  • IMG_3643
  • IMG_3644
  • IMG_3645
  • IMG_3646

Add Reply

This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)

Link copied to your clipboard.