Skip to main content

I performed a PS3 upgrade on a Premier EP5 and realized after it was too late that the wire routing for the LED marker lights did not have the clearance as I had planned.  Although the wires were held in place, they were in direct contact with one of the flywheels.  This in turn removed the wire insulation and created a short.  All functions of the board are intact with the exception of circuits 31 & 33 (as listed on page 16 of the upgrade manual). The headlights and interior lights all work correctly.

Can this be repaired?  Also, is there a way to test the marker lights for functionality?  The torn insulation has been repaired and the short removed, but I would not want to install a repaired board only to damage it once again. 

Thanks!

Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
Link copied to your clipboard.
×
×