Surprised that no one answered you, Bill.

By two different numbers, I assume that you mean their ID numbers in your DCS are different.  If both locos are on the same track, do they respond separately?

Try deleting your lashup.  This should reset them.  Adjust the sound levels so they are about equal.   Note which direction they go when started.  Also, run them on the same track, a few inches apart, to make sure they move at the same speed.  If their speeds are not very close to equal, don’t lash them together.  Now rebuild your lashup just make sure that you observe the direction so both want to go the same way.

Hopefully this works for you.

Dan

Add Reply

Likes (0)
Post
The DCS Forum is sponsored by
OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×