Skip to main content

I had a Mediatronics discharge unit for my NJ switch machines on Gargraves switches.  It conked out after a couple years. I only operate one switch at a time.  Can anybody recommend a replacement that will suffice?  I was feeding it 20 v from a KW, as they could get a bit sluggish with less, especially when activated by an AIU.  Is that too much?

Original Post

Replies sorted oldest to newest

JPS,

The capacitor discharge unit itself is the means to keeping switch machines from getting sluggish.  If they still don't snap well after inserting one of them in the circuit, like the Miniatronics PDC1, then you have a substantial mechanical problem with the machines, and/or linkages and points as well.

Miniatronics has not posted its instruction sheet for the PDC1 online, and I don't personally have a paper copy to review it, but your hunch on supply voltage is likely right on target.

What it has published is this:

Click here for more: Miniatronics Super-Zapper Capacitive Discharge Unit)

As a rule of thumb for all electronics I wouldn't go more than 10% over the recommended operating voltage in order to be safe (and many people say 5% to be extra safe).

As a result, applying 20 VAC probably killed it.

And, it would be a good idea to check out the mechanicals of your switch machine installation before proceeding with replacing your PDC1.

Mike

Attachments

Images (1)
  • mceclip1
Last edited by Mellow Hudson Mike

I used one from Dallee electronics in Leona PA.  Used it on a diode matrix board which would fire a multitude of NJ switch machines with one push button to align as many turnouts as needed upon entering a particular track in a large passenger terminal.

CD systems are great and usually very dependable, capable of long life.   We used them in racing (totally different world) for years in very rough salt water situations.

Thanks for all the input.  Over the years I lost a bunch of machines with burned out coils which jammed for whatever reason.  I was able to rebuild most of them.  It takes a little more juice as they are under table and operate with a swivel linkage.  Some of my old wiring might be weak, and tripping them with my AIU saps more power.  I even wound up stretching the springs on some of them.  I was afraid the 20v output might overdo it.  When I get the replacement I'll use the variable output of the KW to bring it down.  In my mid 70s I really don't relish crawling under the table to fix switch machines much. 😐

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×