Skip to main content

I need some help locating where to find connectors that will fit the RS5 mother board.  Specifically, I need -

  • The 2 position connector for the coupler
  • The 3 position connector for the IR sensor
  • The 4 position connector for the battery/speaker
  • The 6 position connector for the rear lamp.

These are a bit smaller than the connectors I have that were from the older TMCC.  Those are 2.4mm on-center???

I did find some of these in the Lionel Harness parts, but not all.  BTY, these are 2mm on-center pin.

I have no problem ordering an entire set if needed.

I'll have to purchase a crimp tool as well.

Thanks for your help.

Attachments

Images (1)
  • 341471691MB000B0: RS5 mother board
Original Post

Replies sorted oldest to newest

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×